SV-216576r531085_rule
V-216576
SRG-NET-000019-RTR-000008
CISC-RT-000280
CAT I
10
This requirement is not applicable for the DODIN Backbone.
Configure the ingress ACL of the perimeter router connected to an alternate gateway to only permit packets with destination addresses of the site's NIPRNet address space or a destination address belonging to the address block assigned by the alternate gateway network service provider as shown in the example below.
R5(config)#ip access-list extended FILTER_ISP
R5(config-ext-nacl)#permit tcp any any established
R5(config-ext-nacl)#permit icmp host x.12.1.16 host x.12.1.17 echo
R5(config-ext-nacl)#permit icmp host x.12.1.16 host x.12.1.17 echo-reply
R5(config-ext-nacl)#permit tcp any host x.12.1.22 eq www
R5(config-ext-nacl)#permit tcp any host x.12.1.23 eq www
R5(config-ext-nacl)#permit 50 any host x.12.1.24
R5(config-ext-nacl)#permit 51 any host x.12.1.24
R5(config-ext-nacl)#deny ip any any log-input
R5(config-ext-nacl)#end
This requirement is not applicable for the DODIN Backbone.
Step 1: Verify the interface connecting to ISP has an inbound ACL as shown in the example below.
interface GigabitEthernet0/2
description Link to ISP
ip address x.22.1.15 255.255.255.240
ip access-group FILTER_ISP in
Step 2: Verify that the ACL only allows traffic to specific destination addresses (i.e. enclave’s NIPRNet address space) as shown in the example below.
ip access-list extended FILTER_ISP
permit tcp any any established
permit icmp host x.12.1.16 host x.12.1.17 echo
permit icmp host x.12.1.16 host x.12.1.17 echo-reply
permit tcp any host x.12.1.22 eq www
permit tcp any host x.12.1.23 eq www
permit 50 any host x.12.1.24
permit 51 any host x.12.1.24
deny ip any any log-input
Note: An Approved Gateway (AG) is any external connection from a DoD NIPRNet enclave to an Internet Service Provider, or network owned by a contractor, or non-DoD federal agency that has been approved by either the DoD CIO or the DoD Component CIO. This AG requirement does not apply to commercial cloud connections when the Cloud Service Provider (CSP) network is connected via the NIPRNet Boundary Cloud Access Point (BCAP).
If the ingress ACL bound to the interface connecting to an alternate gateway permits packets with addresses other than those specified, such as destination addresses of the site's NIPRNet address space or a destination address belonging to the address block assigned by the alternate gateway network service provider, this is a finding.
V-216576
False
CISC-RT-000280
This requirement is not applicable for the DODIN Backbone.
Step 1: Verify the interface connecting to ISP has an inbound ACL as shown in the example below.
interface GigabitEthernet0/2
description Link to ISP
ip address x.22.1.15 255.255.255.240
ip access-group FILTER_ISP in
Step 2: Verify that the ACL only allows traffic to specific destination addresses (i.e. enclave’s NIPRNet address space) as shown in the example below.
ip access-list extended FILTER_ISP
permit tcp any any established
permit icmp host x.12.1.16 host x.12.1.17 echo
permit icmp host x.12.1.16 host x.12.1.17 echo-reply
permit tcp any host x.12.1.22 eq www
permit tcp any host x.12.1.23 eq www
permit 50 any host x.12.1.24
permit 51 any host x.12.1.24
deny ip any any log-input
Note: An Approved Gateway (AG) is any external connection from a DoD NIPRNet enclave to an Internet Service Provider, or network owned by a contractor, or non-DoD federal agency that has been approved by either the DoD CIO or the DoD Component CIO. This AG requirement does not apply to commercial cloud connections when the Cloud Service Provider (CSP) network is connected via the NIPRNet Boundary Cloud Access Point (BCAP).
If the ingress ACL bound to the interface connecting to an alternate gateway permits packets with addresses other than those specified, such as destination addresses of the site's NIPRNet address space or a destination address belonging to the address block assigned by the alternate gateway network service provider, this is a finding.
M
4027